12
7.
PREPARING FOR PROFILING
Before use, make sure that the characteristics of the sheet used correspond to the profiling capacity of
the machine (see "GENERAL CHARACTERISTICS - DETAILED CHARACTERISTICS" chapter 3).
Lower the input guides, using the
A4
locking bolts.
Unlock the sliding bank using the
A3
handle.
Open up the profiling banks
Manually move the metal strip forward inside the machine.
Adjust the width of the inlet guides to the width of the sheet metal strip.
Use the clamping handle
A3
to lock the train in position
The material must be able to slide between the guides without any lateral movement.
Too tightly adjusted
→
Sheet jams
Adjusted with too much give
→
Imprecise profiling
Be sure to tighten the
A3
handle sufficiently to avoid any inadvertent movement of the bank during the
roll-forming.
Wear appropriate, lightweight clothing that you are comfortable in.
Put on your safety shoes to avoid accidents due to anything falling to the floor. Put on gloves to avoid cuts.
EN
G
A1
A2
A3
A4
Summary of Contents for 084745
