14
10. Profiling in two passes
Some trays must be done in two runs. To do this you have to perform the profiling twice: one on each side of the
sheet metal.
The width of the input sheet guides must be adapted so that only one of the profiling trains forms the sheet. The
second train turns freely.
- Slide the moving bank fully out.
Beware of the risk of collision if the machine is not open enough.
- When profiling, the sheet must be held correctly to obtain a good profile.
EN
G
Summary of Contents for 084745
