4
Maintenance
WARNING:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire, electric
shock or damage to persons.
Light Bulb Replacement
CAUTION:
Allow at least five (5) minutes for light bulbs to
cool off before touching bulbs to avoid accidental burning of
skin.
Light bulbs need to be replaced when you notice a dark
section of the flame or when the clarity and detail of the log
exterior disappears. There are two bulbs under the log set
which generate the flames and embers.
Tool Requirements:
Phillips screw driver
Helpful Hints:
It is a good idea to replace all light bulbs at
one time if they are close to the end of their rated life. Group
replacement will reduce the number of times you need to
open the unit to replace light bulbs.
Light Bulb Requirements:
Quantity 4 clear chandelier or
candelabra bulbs with an E-12 (small) socket base, 60 watt
rating. Example GE 60BC or Philips 60CTC
CAUTION DO NOT EXCEED 60 WATTS PER BULB
Light Bulb Replacement
1. Open the steel curtains (remove glass doors if appli-
cable).
2. Remove the log grate retaining screws and remove the
log grate.
3. Pull the rear edge of the log set forward by grasping the
ember bed by the sides (handle the log set only by the
ember bed and not the logs) and pulling firmly until the
rear tab pops out from under the back ledge, then lift out.
4.
Examine to determine which bulbs require replacement.
5. Unscrew bulb counter clockwise.
6. Insert new bulb screwing clockwise.
7. Replace the log set by inserting the front edge, pushing
the back down until the rear tab snaps under the back
ledge and the logs are resting against the partially reflec
-
tive glass.
Glass Cleaning
The clear door is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
clear door may collect dust particles, these can be removed
by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water spots.
To prevent scratching, do not use abrasive cleaners or spray
liquids on the clear door surface.
Servicing
WARNING:
Except for light bulb replacement
and cleaning described above, an authorized service
representative should perform any other servicing.
