3
OPTIFLAME ELECTRIC FIREPLACE
OPERATION
REMOTE CONTROL
The Optiflame fireplace is supplied with a
radio frequency remote control (all models
except BF36E). This remote control has a
range of approximately 50ft. (15.25m), it does
not have to be pointed at the fireplace and can
pass through most obstacles (including walls).
It is supplied with one of 243 independent
frequencies to prevent interference with other
units. The frequency designation is indicated
on the back of the transmitter (FIGURE 1).
A. Remote Control Initialization
This procedure is required every time there is
a loss of power to the remote control in the
fireplace (i.e. power failure, breaker tripped,
main power switch is turned off)
1. Ensure that power is supplied through
main service panel.
2. Access the manual controls, (remove glass
doors if applicable) pull right hand edge of
right hand steel curtain towards the center
of unit. (FIGURE 2)
3. Locate manual controls refer to FIGURE 3.
4. Activate main power switch, red indicator
light 1 will flash.
5. Press ON button located on the remote
control transmitter (FIGURE 1). This will
synchronize the remote control transmitter
and receiver.
FIGURE 1
B. Remote Control Usage
The remote control operates the fireplace
levels sequentially. The level is increased
every time the ON button on the transmitter is
pressed. The fireplace can be turned off at
any point by pressing the OFF button on the
remote control transmitter.
FIGURE 1
