11
KDS6401E
If the stove was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/FLAME ROD
1. Remove the stove pipe kit (if equipped).
2. Remove the four screws from the rear panel and remove.
3. Locate the flame motor and flame rod assembly, remove the motor mounting screws
with a short handled screw driver.
4. Locate and remove the wiring connections and remove the flame rod and flame
motor assembly.
NOTE:
When removing the flame motor some damage may occur to the flame rod.
If flame rod is damaged replace to insure proper operation.
5. To remove the flame rod attach needle nose pliers to the spring on the motor shaft
and pull while rotating in the opposite direction of the spring winding.
6. To replace the flame rod attach needle nose pliers to the flame rod spring and push
onto the flame motor shaft while rotating in the opposite direction of the spring
winding.
7. Properly orientate the flame motor and connect all of the wiring clips connections in
their original locations.
