9
Fireplace Installation
cable ties as shown in Figure
2 and remove the cardboard
that protects the log set.
Place the Front Glass onto
6.
the track of the fireplace
(Figure 3) and slide it along
the front until it reaches the
far left of the unit.
re-attach the right hand
7.
trim piece using the four (4)
Philips screws from step 4.
Fireplace Installation
Install the fireplace assembly
into the mantel (refer to mantel
assembly instructions).
!
NOTE 1:
A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if after installation
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
CAUTION:
Clearance for
air circulation beneath the
fireplace insert is provided by
two spacers.
Do not install
the fireplace insert directly
on carpet or similar surfaces
which may restrict air
circulation.
If installing the
fireplace in a carpeted area,
place a one-piece, solid, flat
Figure 3
Figure 2
Foam
Block
Cable
Ties
Front
Glass
Trim
Track
