7
3-POSITION SWITCH REPLACEMENT
Tools Required:
Phillips Head Screwdriver
Flat Head Screwdriver
CAUTION:
If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
WARNING:
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the front glass and set aside in a safe place.
3.
Remove the firebox from the mantel by removing the
retaining screws which secure the firebox brackets to
the mantel.
4. Remove the three screws along the back of the unit,
the two on either side along the top edge and the one
along the front (below the glass hanging standoff) on
both sides. (Figure 3)
5.
Lay the Compact Fireplace on its back.
6. Gently open the top panel, laying it on the work sur-
face so that all of the components can easily be seen.
(Figure 4)
7. Locate the Main Power switch and disconnect the wir-
ing connections noting their original locations.
!
NOTE:
A flat head screwdriver can be used to gently
pry between the end of the connector and the switch to
release the wires.
8. Depress the retainer clips on the rear of the switch and
push the switch out through the opening.
9. Properly orient and insert the new switch and connect
all of the wiring.
10. Reassemble in the reverse order as above.
Figure 3
HEATER ON/OFF SWITCH
REPLACEMENT
Tools Required:
Phillips Head Screwdriver
Flat Head Screwdriver
CAUTION:
If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
WARNING:
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the front glass and set aside in a safe place.
3.
Remove the firebox from the mantel by removing the
retaining screws which secure the firebox brackets to
the mantel.
4. Remove the three screws along the back of the unit,
the two on either side along the top edge and the one
along the front (below the glass hanging standoff) on
both sides. (Figure 3)
5.
Lay the Compact Fireplace on its back.
6. Gently open the top panel, laying it on the work sur-
face so that all of the components can easily be seen.
(Figure 4)
7. Locate the Heat On/Off switch and disconnect the wir-
ing connections noting their original locations.
!
NOTE:
A flat head screwdriver can be used to gently
pry between the end of the connector and the switch to
release the wires.
8. Depress the retainer clips on the rear of the switch and
push the switch out through the opening.
9. Properly orient and insert the new switch and connect
all of the wiring.
10. Reassemble in the reverse order as above.
Figure 4
Top Panel
Remote Control Receiver
3-Position Switch
Heater On/Off Switch
Thermostat
Heater
Assembly
Power Cord
