4
www.dimplex.com
When using electrical appliances,
basic precautions should always be
followed to reduce the risk of fire,
electric shock, and injury to persons,
including the following:
①
Read all instructions before using
this appliance.
②
The heater is hot when in use.
To avoid burns, do not let bare skin
touch hot surfaces. The trim around
the heater outlet becomes hot during
heater operation.
③
Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever the
unit is left operating and unattended.
④
Always unplug the fireplace when
not in use.
⑤
Do not operate any heater after it
malfunctions. Disconnect power at
the service panel and have the unit
inspected by a reputable electrician
before reusing.
⑥
Do not operate any unit with a
damaged cord or plug, or if the heater
has malfunctioned, or if the electric
fireplace has been dropped or dam
-
aged in any manner,
contact Dimplex
Technical Service at 1-888-346-7539.
⑦
Do not use outdoors.
⑧
Do not run the cord under carpet
-
ing. Do not cover cord with throw
rugs, runners or the like. Arrange
IMPORTANT INSTRUCTIONS
cord away from traffic area and where
it will not be tripped over.
⑨
To disconnect the unit, turn the
controls off, then remove the plug
from the outlet.
⑩
Do not insert or allow foreign
objects to enter any ventilation or
exhaust opening as this may cause
an electric shock or fire, or damage to
the heater.
⑪
To prevent a possible fire, do not
block air intake or exhaust in any
manner.
⑫
All electrical heaters have hot and
arcing or sparking parts inside. Do
not use in areas where gasoline,
paint, or flammable liquids are used
or stored.
⑬
Do not modify the fireplace. Use it
only as described in this manual. Any
other use not recommended by the
manufacturer may cause fire, electric
shock or injury to persons.
⑭
To reduce the risk of electric
shock, this appliance has a polar
-
ized plug (one blade is wider than the
other). This plug will fit in a polarized
outlet only one way. If the plug does
not fit fully in the outlet, reverse the
plug. If it still does not fit, contact
a qualified electrician to install the
proper outlet. Do not change the plug
in any way.
