7
Custom Mantel Construction
1. Frame an opening of, see
dimensions in Figure 1:
!
NOTE:
On elevated instal
-
lations, the bottom edge and ½
in. (13 mm) up either side will
be easily visible after installa
-
tion (Figure 2). This area should
be finished in a manner that is
visually appealing and does not
restrict air flow to the unit.
Option #1
- The power cord can
be lead from behind the trim
and along the wall to an outlet
near the fireplace.
Option #2
- A new outlet can be
installed inside the new frame
construction. Plug the unit into
a 15 Amp/120 Volt outlet.
!
NOTE:
A 15 Amp, 120 Volt
circuit is required. A dedicated
circuit is preferred but not es
-
sential in all cases. A dedi
-
cated circuit will be required
if, after installation, the circuit
breaker trips or fuse blows
on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating
of the circuit breaker.
Bathroom Installation
This firebox must be protected by
a GFI receptacle or circuit. If a
receptacle is used it must be readily
accessible.
To prevent electrical shock this unit
is an electrical appliance that is not
watertight and must be installed as to
prevent water from entering the unit.
This unit must be installed away from
showers, tubs, etc. Never locate fire
-
place where it may fall into a bathtub
or other water containers.
Figure 1
Fireplace Installation
A
B
C
PF2325
25.0in.
(635mm)
18.5in.
(470mm)
10.0in.
(254mm)
PF3033
32.1in.
(816mm)
22.8in.
(579mm)
10.0in.
(254mm)
!
NOTE:
The fireplace needs to be
installed to ensure 80 in
2
(516 cm
2
) of
intake air, into the back of the unit, on
a continuous basis.
A
B
C
