20
www.dimplex.com
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the heater
off and it will not come back on without
being reset.
If the fireplace is installed with a
plug, it can be reset by unplugging
the fireplace, waiting 5 minutes and
plugging back in.
If the fireplace is hard-wired, it can
be reset by turning of the electrical
breaker, waiting 5 minutes and turning
the breaker back on.
CAUTION
: If you need to con-
tinuously reset the heater, unplug
the unit and call technical support
at 1-888-346-7539.
General Maintenance
Inspect the electric fireplace regularly,
depending upon conditions, and at a
minimum yearly intervals. Remove dust
and clean the logs, grate, and base as
required.
WARNING:
Disconnect power
and allow heater to cool before
attempting any maintenance or
cleaning to reduce the risk of fire,
electric shock, or injury.
CAUTION
: Except for installation
and cleaning described in this
manual, an authorized service
representative should perform any
other servicing.
Clean Logs and Base
The electric fireplace set should not be
operated with an accumulation of dust
or dirt on or in the fireplace, as this can
cause a build-up of heat and eventual
damage.
Dust and vacuum the fireplace as
needed. Use a damp cloth and a mild
detergent to clean painted surfaces
of the electric fireplace. Never use
abrasive cleaners.
Maintenance
