INSTALLATION
MANUAL CONTROL REMOVAL
1. Open steel curtain (remove glass doors if
applicable).
2. Remove two screws on log grate and
remove log grate (FIGURE 4).
3. Pull front edge of plastic ember bed grate up
and forward until rear tab releases from the
ledge located at the bottom of the mirror.
(FIGURE 5)
Note: Log set fits tightly into firebox, some
force may be necessary to remove.
(FIGURE 5)
4. Locate and remove the two screws on the
manual control bracket. Remove the
bracket. (FIGURE 6)
5. Locate and depress the mounting tabs on
the plug connector and remove the manual
control bracket. (FIGURE 6)
REMOTE CONTROL INSTALLATION
1. Locate and insert the plug connector on the
remote control bracket into plug connector
on the fireplace. FIGURE 7)
2. Locate and install the two screws on the
remote control bracket.
3. Replace the log by inserting front edge and
pushing the back down until rear tab snaps
under back ledge (FIGURE 5) and the logs
are resting against mirror.
4. Replace log grate using two screws
previously removed.
FIGURE 4
FIGURE 5
MANUAL CONTROL
MANUAL CONTROL
DEPRESS MOUNTING
TABS
FIGURE 6
REMOTE CONTROL
PLUG CONNECTOR
PLUG CONNECTOR
FIGURE 7
