Setting
Manual
or
Remote
Operation
Indication
Flame
effect
Press
the
‘ON’
button
once
Bottom
Neon
Flame effect & 1kW heat setting
Press the ‘ON’ button again
Bottom & Middle Neon
Flame effect & 2kW heat setting
Press the ‘ON’ button again
All 3 Neon’s
To turn off any of the settings
Press the ‘OFF’ button once.
To increase or decrease the brightness of the fuel effect use the buttons as shown in Fig. 4.
Fig.3
Fig.4
Manual or Remote Operation
1.
Slide open the battery cover on the back of the
remote control
2.
Install three AAA batteries into the remote control
(see Fig. 3)
3.
Replace the battery cover.
Batteries
Remote Control Oper
Warning: it takes some tim
respond to the transmitter
Decrease Brightness
Off Button
Increase Brightness
On Button
Standby
Switch
OFF
ON
ation
e for the receiv
. Do not press th
er to
e buttons
more than once within two seconds for correct
operation.
Manual Controls
Note:
The Standby Switch must be first
turned on to operate either the manual
or the remote controls.
