10
www.dimplex.de
Fireplace Installation
partially reflective glass and
glass brackets using screws
from step 1.
refer to Front Glass
12.
Installation section, for final
installation procedures.
In-wall Recessed
Installation - 100mm Deep
CAUTION:
Two people may
be required for various steps
of this procedure.
Prepare a wall with a framed
1.
opening of 118.1 cm wide x
42 cm high (Figure 4).
!
NOTE:
The sizing has allowed
for 6.4mm around the fireplace
insert for ease of installation. this
fireplace does not require any
additional venting.
Choose your method of
2.
supplying power to the unit:
Plug in (you may run the
•
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
Hard wire the fireplace.
•
!
NOTE:
Hard wiring can
be done by removing the plug
from the factory fitted cord and
Figure 5
Mounting
holes
Figure 4
