12
Fireplace Installation
additional venting.
2. Choose your method of
supplying power to the unit:
•
Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace.
!
NOTE:
Hard wiring can
be done by removing the plug
from the factory fitted cord and
completing the wiring according
to national and Local elecrical
Codes.
WARNINg:
Do not attempt
to wire your own new outlets or
circuits. to reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
ensure that the 3-Position Switch is
set to the Off position ("O") and that
the circuit on which the fireplace is
to be installed has the power cut off
at the service panel until installation
is complete.
3. Lift fireplace and insert into
opening. the fireplace's
mounting trim should be flush
against the wall (Figure 8).
4.
Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive four (4) supplied
mounting screws through the
four (4) mounting holes located
on the inside surface of the
Figure 6
Mounting
hole
Figure 7
Summary of Contents for BLF74-EU
