Dimplex Bramdean BMD20, Operating Instructions Manual

This heater must be used on an AC ~ supply only and the voltage marked on the heater must 

correspond to the supply voltage. Before switching on, please read the safety warnings and 

operating instructions. Please retain this user’s guide for future reference

Ensure that all packing items are removed (read any warning labels carefully). Retain all packing 

for possible future use e.g. in the event of moving or returning the appliance to your supplier.

To install the appliance;

1.   Clean the area where the fire will be installed.

2.   Hold the fire by the sides of surround and gently manoeuvre into position. 

3.    Plug the fire into a 13amp/240 volt outlet. Ensure that the supply cable is not trapped under 

the fire such that it might cause it to be damaged.

4.   Ensure that the draft excluder (rubber strip) is fitted to the channel on the base of the product.

Connecting the Transducer

1.    Gently lift out the fuelbed and carefully set aside. (Fig 3)

2.    Remove the water tank by lifting upwards and outwards. (Fig 4)

3.    Remove the nozzle by unclipping and lifting upwards and outwards. (Fig 5)

4.    The transducer will be inside the sump. Remove from its bag.

5.    Place the Transducer unit into the sump and make the connection.

6.    Locate the tab on the Transducer unit into the moulded recess in the base of the sump (Fig 6)

7.    Ensure that the cable does not obstruct the Transducer disc. To prevent the cable becoming 

pinched between the nozzle and the sump, place the cable in the slot in the wall of the sump. 

(Fig 7)

Filling the Water Tank

1.   Gently lift out the fuelbed and carefully set aside.

2.   Remove the water tank by lifting upwards and outwards.

3.   Place the water tank in sink and remove cap, Anti-clockwise to open. (Fig 8)

3.    

Fill tank with filtered tap water only. This is necessary to prolong the life of the flame and 

smoke producing unit. The water should be filtered through a conventional domestic water 

filter unit and the filter should be replaced regularly.

6.    Screw the cap back on, do not over tighten.

7.    Return the tank to the sump, with the tank cap facing down

8.    Gently place the fuelbed back into position.

When the water tank is empty, the flame and smoke effect shuts off, you will hear 2 audible beeps 

and the digital display will display 

Installation Instructions

4