Operation Temperature
-20°C to 40°C
Fixed Wiring
In such instances this appliance must be installed by a suitably quailified installer
and the means for disconnection must be incorporated in the fixed wiring in accord-
ance with the local wiring rules.
WARNING
Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electric shock, or injury to persons.
NOTE:
A 10 Amp circuit is required. A dedicated circuit is preferred, but not essential
in all cases. A dedicated circuit will be required if, after installation, the circuit break-
er trips or the fuse blows on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the circuit breaker.
Unpacking the Unit
The unit comes packed with a protective sheet covering the front of the unit. This
sheet is intended to prevent dust and debris from entering during construction. This
sheet is designed so that it can be partially removed to complete the wiring and un-
packing and can be reinstalled until the final installation is complete. The log set was
installed on the grate
and the grate permanently fixed to the firebox at the factory. Carefully remove the
packaging from around the log set. Make sure the wires from the log set are con-
nected securely
to the grate box.
CAUTION
The Realogs contain LED's to create a unique pulse and glow effect. Han-
dle the log set carefully. They are fragile and can crack or break if dropped.
This product is provided with a ‘Tipping Restraint Kit’ as shown below, to prevent
the product accidentally tipping over. Fitting Instructions are supplied with this kit
please follow these instructions carefully.
Setup & Product Dimensions
6