11
Fireplace Installation
①
Make sure the unit's Main ON/
OFF switch (Switch 1) is switched
OFF (refer to operating instruction
section).
②
Plug the unit into a 15 Amp,
120 VAC outlet. If the cord
does not reach, you may use
an extension cord rated for a
minimum of 1875 Watts.
Operation
The fireplace has two (2)
switches. A switch is in the ON
position when the side with the
markings on (i.e. I, II) is pushed in
(Figure 1).
Switch 1
(I)
Manual mode
Controls the electricity supply to
the heater and flame manually.
(II)
Remote mode
Allows the control of electricity
supply to the heater and flame
through the use of the supplied
remote control.
!
NOTE:
This switch must be in
either the (I) or (II) position to
operate with or without heat.
Switch 2
The fireplace operates with flame
effect only unless this switch is in
the (I) position, which will provide
840 Watt heat.
Figure 1
Switch 1
Switch 2
www.sylvane.com 1-800-934-9194
