8
www.dimplex.com
Operation
WARNING:
This electric
firebox must be properly installed
before it is used.
Manual Controls
The manual controls for the
fireplace are located in the upper
right hand corner (Figure 1).
A. On/Off Switch
Supplies power to the 3-position
manual control switch.
B. 3-Position Switch
Remote (left position):
The
unit is operated with the
remote control.
Flame (center position):
The
flame effect is turned ON.
Flame & Heat (right
position):
The flame effect
and heater are turned ON
simultaneously. When the
manual control is in the
Flame
& Heat
position the heater
does not run on the remote
operated thermostat.
!
NOTE:
When the 3-position
switch is in the
Flame
and
Flame & Heat
positions, the
fireplace unit will not operate
with the remote control.
C. Initialization Button
Used to synchronize the remote
control.
!
NOTE:
The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will not
occur again.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset. The
temperature cutoff switch can
be reset by unplugging the unit,
waiting five minutes and plugging
the unit back in.
CAUTION:
If you need to
continuously reset the heater,
unplug the unit and call Dimplex
North America Limited at 1-888-
346-7539. Please have your
Figure 1
A
B
C
