15
Maintenance
③
Set logset in front of fireplace.
④
Disconnect the logset LED
wire harness from unit.
⑤
unscrew bulbs counter
clockwise.
⑥
Insert new bulbs.
⑦
Reconnect the logset LED
wire harness.
⑧
Replace the logset by inserting
the front edge of the fireplace and
push down on the rear edge of
the emberbed until it snaps into
place (Figure 6).
!
NOTE:
Ensure the logset is
installed tightly under the back
ledge to prevent light leakage.
⑨
Replace glass assembly.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 15 Watts per
bulb
To access the upper light bulb
area (Figure 5):
①
Remove front glass assembly.
②
Remove upper light cover.
③
upper bulbs located in the
upper left and upper right corners
of fireplace (Figure 5).
④
unscrew bulbs counter
clockwise.
⑤
Insert new bulbs.
⑥
Re-install upper light bracket.
⑦
Replace glass assembly.
glass Cleaning
The glass is cleaned in the factory
during the assembly operation.
During shipment, installation,
Back
Ledge
Log
Ember bed
Rear
Tab
Front
Edge
Side Section
Figure 6
