11
Remote Control Initialization
1. Place the Main On/Off Switch (Figure 7A) in the OFF (“
O
”)
position.
2. Wait a minimum of five (5) seconds and then place the Main On/Off
Switch in the Remote Control (“ ”) position.
3. Within 10 seconds of changing the switch position, press the ON
button located on the remote control transmitter (Figure 8). This will
synchronize the remote control transmitter and the stove receiver.
!
NOTE:
You will have only 10 seconds to perform this last step.
Failure to do so will result in these steps needing to be followed
again.
Battery Replacement
To replace the battery:
• Slide battery cover open on the hand held transmitter.
• Correctly install one (1) 12 Volt (A23) battery in the battery holder.
• Close the battery cover.
Resetting the Temperature Cutoff Switch
The heater is protected with a safety device to prevent overheating.
Should the heater overheat, an automatic cut out will turn the heater
off and it will not come back on without being reset. It can be reset by
switching the ON/OFF Switch to OFF and waiting 5 minutes before
switching the unit back on.
CAUTION:
If you need to continuously reset the heater, unplug the
unit and call Dimplex North America Limited at 1-888-346-7539.
!
NOTE:
The heater may emit a slight, harmless odor when first
used. This odor is a normal condition caused by initial heating of
internal heater parts and will not occur again.
