4
OPERATION
BEFORE FIRST USE
• Please read these instructions carefully before use and keep them for
future reference.
• Check your local main voltage whether it is the same as stated on the
appliance.
• Before using for the first time, remove any protective films or stickers
from the appliance and ensure the power switch is in the “0” position.
ASSEMBLY
1. Remove the pole fixing nut (16) from the main pillar (14) and insert the
main pillar (14) into the base (15) then tighten the fixing nut (16).
2. Release fixing screw B (13) and adjust height to a suitable length. Re-
tighten the fixing screw B once ready.
3. Release the fixing screw A (11), connect the motor housing with the
upper pillar (12), fasten it with the fixing screw A (11).
4. Remove the blade locking cap (2) and the guard knob (4) from the
motor shaft (6), secure the rear guard (5) on the motor housing (9) to
line up with the three fixing pins, fasten the guard with the guard knob
(4).
5. Put the blade (3) on the motor shaft (6) and tighten with the blade
locking cap (2).
6. Attach the front guard (1) to the rear guard (5), and close the guard
fixing clips, finally fastening with the safety screw (17).
