11
POWER CORD REPLACEMENT
Tools Required:
Phillips head screwdriver
Needle nosed pliers
WARNINg:
If the fireplace was operating prior to
servicing allow at least 10 minutes for light bulbs and
heating elements to cool off to avoid accidental burning
of skin.
WARNINg:
Disconnect circuit power before attempt-
ing any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
Remove the firebox trim by grasping both sides of the
1.
trim and pulling straight up.
Remove the firebox from the mantel.
2.
Remove the 6 retaining screws on the edges along the
3.
top cover: 2 on the left; 2 on the right; 2 on the back.
Remove the top, placing it upside down on the top of
the unit being careful not to damage any of the wiring.
Locate and disconnect the power cord wiring connec-
4.
tions noting their original locations.
With needle nose pliers grasp the power cord strain
5.
relief grommet from inside the right rear of the panel
and push while twisting to remove.
Pull the power cord out through the hole in side of the
6.
unit.
Insert the new power cord through the hole and con-
7.
nect all of the wiring connections in their original loca-
tions.
Install the power cord strain relief grommet on the
8.
replacement power cord and insert into the mounting
hole.
WARNINg:
Ensure wires do not come in contact with
moving parts by securing wires in wiring tie wraps.
Reassemble in the reverse order as above.
9.
REMOTE CONTROL RECEIVER
REPLACEMENT
Tools Required:
Phillips head screwdriver
Needle nosed pliers
WARNINg:
If the fireplace was operating prior to
servicing allow at least 10 minutes for light bulbs and
heating elements to cool off to avoid accidental burning
of skin.
WARNINg:
Disconnect circuit power before attempt-
ing any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
Remove the firebox trim by placing your hand on the
1.
grille section, grasping the sides of the trim and pulling
forward, away from the firebox, releasing the retainer
clips.
Remove the firebox from the mantel.
2.
Lower the grille covering the controls.
3.
Remove the 6 retaining screws on the edges along the
4.
top cover: 2 on the left; 2 on the right; 2 on the back.
Remove the top, placing it upside down on the top of
the unit being careful not to damage any of the wiring.
Locate the Remote Control Receiver, next to the ther-
5.
mostat control, and disconnect the wiring connections
noting their original locations.
!
NOTE:
Markings on the new board may appear differ-
ent than the original, however position of the wires on the
new board should be the same configuration as the original
board.
From under the panel, break off the four mounting
6.
studs on the Remote Control Receiver, push the re-
mainder of the studs out through the top panel.
!
NOTE:
New mounting studs are supplied with the
replacement Remote Control Receiver.
Remove the Remote Control Receiver.
7.
Properly orient the new Remote Control Receiver and
8.
secure it to the unit using the new plastic mounting
studs.
Connect all of the wiring connections according to their
9.
original configuration.
Reassemble in the reverse order as above.
10.
Summary of Contents for DF2600
Page 7: ...7 WIRING DIAGRAM ...
