2
OPEN
EF3003, SF3003, DF3003
OPERATION
Initializing The Remote Control
1. Turn on the electrical power at the circuit breaker.
2. Slide open the battery cover on the back of the remote transmitter.
3. Install one 9 volt battery into the remote control. Replace the battery cover.
.
Remote Control Operation
The fireplace is supplied with a radio frequency remote control. This remote control has
a range of approximately 50 feet. (15.25 m), it does not have to be pointed at the
fireplace and can pass through most obstacles (including walls). It is supplied withone
of 243 independent frequencies to prevent interference with other units. The frequency
designation is indicated on the back of the transmitter.
Remote Control Initialization
This procedure is required every time there is a loss of power to the remote control in
the fireplace. (ie. Power failure, breaker tripped, main power switch is turned off)
1. Ensure that the power is supplied through the main service panel.
2. Locate manual controls (refer to fig. 1)
3. Activate main power switch (“_” position) red indicator light 1will flash.
4. Press and hold manual selection switch for five seconds (“_” position) UNTIL the
second red indicator light flashes.
5. Press ON button located on the remote control transmitter (fig. 2). This will
synchronize the remote control transmitter and receiver.
The remote control operates the fireplace levels sequentially. The level is increased
every time the ON button on the transmitter is pressed. The fireplace can be turned off
at any point by pressing the OFF button on the remote control transmitter.
