13
taken when handling the glass.
6. Pull the front edge of the plastic Ember Bed or plastic
grate up and forward until the rear tab releases from the
ledge located at the bottom of the Mirror (Figure 6,
page 8).
!
IMPORTANT:
Only handle the Log Set Assembly by the
Ember Bed or plastic grate.
!
NOTE:
Log Set Assembly fits tightly into firebox, some
force may be necessary to remove.
7. Disconnect LED harness (Figure 7, page 8).
8. Set Log Set Assembly in front of firebox.
9. Loosen but do not remove the two (2) Philips screws that
clamp the Mirror in place, and swivel down so that the
clamp clears the edge of the Mirror (Figure 8, page 8).
10. Push the Mirror out from behind to clear the frame and
remove.
11. Remove the 14 screws that attach the top panel to the
firebox. There are: one (1) screw on either side of the
Purifire™ filter; two (2) on each side; and a total of eight
(8) on the top panel (Figure 11).
CAUTION:
Internal wiring and colors may not be the
same within the unit being serviced as those shown. To
avoid damage to the unit, damage to property or personal
injury, ensure wires are reconnected to match their
original locations.
16. Feed Antenna wire through rubber housing and out the
back corner of the firebox.
17. Follow steps 1 through 12 in reverse order to re-
assemble the firebox.
Heater Assembly and Cutout
Replacement
If the fireplace was operating prior to servicing allow at least
five (5) minutes for light bulbs and heating element to cool off
to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Replacement Procedure
1. Remove the firebox from the mantel.
2. Remove the 14 screws that attach the top panel to the
firebox. There are: one (1) screw on either side of the
Purifire™ filter; two (2) on each side; and a total of eight
(8) on the top panel (Figure 11).
3. Remove top panel and Purifire™ filter (lift filter straight up
and out of firebox).
4. To replace Cutout only:
i) Remove the one (1) small Phillips screw that attaches
the Cutout to the Heater Assembly as shown in
Figure 13.
Figure 11
Screws to Remove
Top View
12. Remove top panel.
13. The Remote Control Receiver board is fastened to the
back, right hand corner panel of the firebox by seven (7)
mounting studs (Figure 12). Squeeze each mounting
stud’s clasp to release the circuit board from the firebox.
!
NOTE:
If mounting studs are damaged, replacement
mounting studs will need to be inserted from the outside
of the firebox. It is recommended to attempt to release
the receiver board without cutting mounting studs.
14. Properly orientate the replacement Remote Receiver
board and push it onto the seven (7) mounting studs until
the clasps of the mounting studs snap the board into
place.
15. Disconnect one of the wire leads from the original control
board (which are still connected to parts within the
firebox) and immediately connect it to the new control
board’s terminal, matching its position. Continue with the
remaining two (2) wires and five (5) cable connectors,
using the same procedure.
Figure 12
Antenna wire
5 color cable to
Flicker Motor
Cable connector to
upper and lower light
harness
Cable connector
to Log Set LED
harness
4 wires to Heater
Assembly
①
②
③
①
②
③
Red wire to Main On/Off Switch
White wire to Cutout
Black wire from power cord
Mounting studs (7)
