11
Figure 5
C
B
A
til you hear the click again and the
heater will turn on.
!
NOTE:
The heater on your
fireplace may emit a slight,
harmless odor when first used.
This odor is a normal condition
caused by the initial heating of
internal heater parts and will
not occur again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the fire
-
place off and it will not come back
on without being reset. It can be
reset by switching the Three Posi
-
tion On/Off switch to Off and wait
-
ing five minutes before switching
the unit back on.
CAUTION:
If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with an
integrated on/off remote control
(Figure 6)
!
NOTE:
Ensure that the fire
-
place's Three Position switch
is set to the remote control
(“
II
”) setting (Figure 6A).
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off.
Remote Initialization/Repro-
gramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
fireplace:
1. Place the 3-Position Switch
(Figure 6A) in the Off (“
O
”)
position.
2. Wait a minimum of five (5)
seconds and then place the
3-Position Switch in the re
-
mote (“
II
”) position.
Operation
