14
www.dimplex.com
Maintenance
motor shaft and replace op
-
posite end of flicker rod back
into support bracket.
9. Replace media tray back into
firebox.
10.
Gently pour and evenly
spread the glass media.
11. Replace glass assembly.
Glass Cleaning
The front glass is cleaned in the
factory during the assembly op
-
eration. During shipment, instal
-
lation, handling, etc., the front
glass may collect dust particles,
these can be removed by dusting
lightly with a clean dry cloth.
To remove fingerprints or other
marks, the glass can be cleaned
with a damp cloth. The glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching,
do not use abrasive cleaners or
spray liquids on the glass surface.
Fireplace Surface Cleaning
To remove fingerprints or other
marks, the exterior finish can be
cleaned with a damp cloth with
a mild detergent. The surface
should be completely dried with
a lint free cloth to prevent water
spots
.
Figure 7
Flicker Rod
Glass media
and Tray
Front Glass
Assembly
