9
Installation
consumption.
2. Remove the outer jacket and
strip the individual conductor
from the end.
3. Loosen the screw securing
the junction box cover and
remove the cover.
4. Take the cables out from the
junction box, loosen the two
wire twist nuts and remove
the cord set (Figure 2).
5.
Route the power supply wire
through the knockout on sup
-
plied alternative junction box
cover and secure with a wire
clamp (not supplied) (Figure
3).
6. Connect the black wire (live)
from the unit to the black wire
from power supply (Figure 3).
7. Connect the white wire
(neutral) from the unit to the
white wire from power supply
(Figure 3).
8. Connect the green wire
(ground) from the unit to the
green wire from power supply
(Figure 3).
9. Place all connectors inside
the unit and secure the junc
-
tion box cover to unit. Ensure
that the cable clamp grips
only the jacket of service
cable.
Wiring
L1
N
N
S
W
IT
CH O
U
T
CUTOUT
THERMOSTAT
M
M
L
H
E
A
T O
N
/O
FF
S
WI
TCH
LIGHT HARNESS
ASSEMBLY
FLICKER
MOTOR
C
APAC
IT
OR
BLOWER
MOTOR
ELEMENT
