6
www.dimplex.com
Stove Installation
WARNING:
This stove is not
to be used on elevated sur-
faces.
Site Selection
!
NOTE:
A 15 Amp, 120 Volt al-
ternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit
will be required if, after instal-
lation, the circuit breaker trips
or fuse blows on a regular ba-
sis when the heater is operat-
ing. Additional appliances on
the same circuit may exceed
the current rating of the circuit
breaker.
WARNING:
Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the pow-
er cord is stored or secured to
avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed electri-
cian.
Installation
1. Remove all packaging from
unit and ensure heater ex-
haust is free from debris and
packaging remnants.
2.
Place unit on floor in desired
location.
Quick Reference Guide
①
The information regarding the
model of your electric stove can
be found on the label located on
the back of the unit.
②
If you have any technical
questions or concerns regarding
the operation of your electric
stove, or require service contact
customer service.
