16
DS5598, DS5603, DS5804
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE HEATER ON/OFF SWITCH
1. Remove the stove pipe kit (if equipped).
2. With front door closed, gently place stove door side down on a flat surface.
3. Remove the retaining screws on the
REAR
stove legs with a screwdriver and
remove the rear legs.
4. Remove the rear cover retaining screw located at the lower center of the rear cover.
5. Slide the rear cover down 4 to 6 inches and gently pull the cover up from both the
top and bottom bowing it slightly and remove it from its mounting slot. When the
cover is removed place beside the stove being careful not to damage any of the
wiring.
6. Locate the heater on/off switch mounted on the rear cover and disconnect the wiring
clips and connections noting their original locations.
7. Depress the retainer clips on the rear of the switch and push the switch out of the
rear cover.
8. Properly orientate the new switch and connect all of the wiring clips and
connections.
9. Reassemble in the reverse order as above.
