10
www.dimplex.com
Operation
Battery Replacement
Slide battery cover open on
the hand held transmitter
(Figure 4).
Correctly install one (1) 12 Volt
(A23) battery in the battery
holder
.
Close the battery cover.
WARNING:
Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of ire, electric
shock or damage to persons.
Light Bulb Replacement
CAUTION:
Allow at least ive
(5) minutes for light bulbs to cool
off before touching bulbs to avoid
accidental burning of skin.
Light bulbs need to be replaced
when you notice a dark section
of the lame or when the clarity
and detail of the log exterior
disappears. There are two bulbs
under the log set which generate
the lames and embers.
Tool Requirements:
Phillips
screw driver
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs.
Upper Light Bulb Requirements
Quantity of one (1) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
7 Watt rating.
Upper Bulb Replacement
Open door by pulling the
1.
step. Failure to do so will
result in these steps needing
to be followed again.
This will synchronize the remote
control transmitter and receiver.
Maintenance
