11
Maintenance
handle.
Locate the upper bulb
2.
bracket.Bend light retainer
bracket down.Locate and
remove the light bulb.Insert
new bulb.
Bend light retainer bracket
3.
back into its original position.
Close the door.
4.
Lower Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
60 Watt rating.
Lower Bulb Replacement
Open door by pulling the
1.
handle.Remove the screw
from the log set located in the
center of the ember bed and
remove the log set from the
unit.
Locate and examine the bulbs
2.
to determine which bulb(s)
required replacement.
Locate and remove the light
3.
bulb(s).
Insert new bulb(s).
4.
Install the log set into the
5.
unit, pushing irmly against
the glass. Replace the log
set retaining screw into the
ember bed.
Close the door.
6.
Glass Cleaning
The clear door is cleaned in
the factory during the assembly
operation. During shipment,
installation, handling, etc., the
clear door may collect dust
particles, these can be removed
by dusting lightly with a clean dry
cloth.
To remove ingerprints or other
marks, the clear door can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
clear door surface.
Plastic Door Cleaning
To remove ingerprints or other
marks, the clear door can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
clear door surface.
