9
Maintenance
WARNINg:
Disconnect power before attempting
any maintenance or cleaning to reduce the risk of
fire, electric shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool
before touching bulbs to avoid accidental burning of
skin. Light bulbs need to be replaced when you notice
a dark section of the flame or when the clarity and
detail of the log exterior disappears. There are two (2)
bulbs under the log set which generate the flames and
embers.
Helpful Hints
It is a good idea to replace all light bulbs at one time
if they are close to the end of their rated life. Group
replacement will reduce the number of times you need
to open the unit to replace light bulbs.
Light Bulb Requirements
Quantity of three (3) – 60 Watt chandelier or
candelabra bulbs with E-12 (small) socket base,
120 Volt.
Do not exceed 60 Watts per bulb.
Bulb Replacement Instructions:
①
Unplug the unit from the outlet.
②
Remove glass assembly as shown in Figure 4.
③
Reach in and turn the burnt-out bulb(s) (or all
bulbs) counter-clockwise to remove.
④
Replace with new bulbs.
⑤
Fit glass assembly back in place.
⑥
Plug in the fireplace.
glass Cleaning
The front glass is cleaned in the factory during the
assembly operation. During shipment, installation,
handling, etc., the front glass may collect dust
particles, these can be removed by dusting lightly with
a clean dry cloth.
To remove fingerprints or other marks, the glass can
be cleaned with a damp cloth. The glass should be
completely dried with a lint free cloth to prevent water
spots. To prevent scratching, do not use abrasive
cleaners or spray liquids on the glass surface.
Fireplace Surface Cleaning
To remove fingerprints or other marks, the exterior
finish can be cleaned with a damp cloth with a mild
detergent. The surface should be completely dried
with a lint free cloth to prevent water spots.
To prevent scratching, do not use abrasive cleaners or
spray liquids on any surface.
