12
www.dimplex.com
Operation
The manual controls for the
electric fireplace are located on
the right side of the unit (Figure 8).
Resetting the Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
3-Position switch to off and
waiting five (5) minutes before
switching the unit back on.
CAUTION:
If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
!
NOTE:
Ensure that the
fireplace’s 3-Position switch
is set to the remote control
setting (“
II
” position).
Figure 8
B
A
A. 3-Position Switch
The switch has two (2) on
positions marked with “
I
” and
“
II
”. The “
I
” position is for
manual operation. In this position
the built-in remote control is
bypassed.
The “
II
” position is for operating
the unit with the provided remote
control. When in “
II
” position
the unit is operated with the ON
and OFF buttons of the remote
control.
When the switch is in the center
(“
O
”) position the unit is off.
B. Heat On/Off Switch
The Heat on/off switch supplies
power to the heater fan and the
heater element.
