8
www.dimplex.com
Site Selection
!
NOTE:
A 15 Amp, 120
volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or the
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNINg:
Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
Fireplace Installation
always use a licensed
electrician.
WARNINg:
The supplied
mounting bracket is designed
for use with Dimplex wall
mounted fireplaces only.
Improper use, or use for
purposes other than intended,
may cause damage or injury.
Installation
WARNINg:
Failure to install
the fireplace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
fire, serious injury, illness or
death.
WARNINg:
The fireplace
requires the wall mounting
bracket screws to be installed
into a minimum of two wall
studs (Figure 2).
Tools Required
#2 Phillips screwdriver
•
Pencil
•
slot screwdriver
•
Bubble level (supplied)
•
Drill, and drill bits as required
•
Approximate time:
30 minutes
for installation
select an appropriate location
1.
to mount the unit on a wall,
above an electrical outlet.
