7
Site Selection
The unit is packaged with two
types of mounting options:
• Wall mounting, Surface
• Support feet, table top
!
NOTE:
A 15 Amp, 120 Volt cir
-
cuit is required. A dedicated circuit
is preferred but not essential in all
cases. A dedicated circuit will be
required if, after installation, the
circuit breaker trips or the fuse
blows on a regular basis when the
heater is operating. Additional ap
-
pliances on the same circuit may
exceed the current rating of the
circuit breaker.
WARNING:
Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the pow-
er cord is stored or secured to
avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
Fireplace Installation
shock or injury to persons,
always use a licensed electri
-
cian.
WARNING:
The supplied
mounting bracket is designed
for use with Dimplex wall
mounted fireplaces only. Im
-
proper use, or use for purpos
-
es other than intended, may
cause damage or injury.
Wall Mounting Instructions
WARNING:
Failure to install
the fireplace as instructed
below may result in damage
to the equipment and or may
expose the user to the risk of
fire, serious injury, illness or
death.
WARNING:
The fireplace
requires the wall mounting
bracket screws to be installed
into a minimum of two wall
studs (Figure 2).
Tools Required
• #2 Phillips screwdriver
• Pencil
• Slot screwdriver
• Bubble level (supplied)
• Drill, and drill bits as required
Approximate time:
30 minutes
for installation
1. Select an appropriate location
