10
www.dimplex.com
to persons.
1. Follow “Component Access” instructions before pro-
ceeding.
2. Locate the power cord and disconnect the wiring con-
nections noting their original locations.
!
NOTE:
A flat head screwdriver can be used to gently
pry between the end of the connector and the switch to
release the wires.
3. With needle nose pliers, grasp the power cord strain
relief grommet from inside the back of the bottom panel
and push while twisting to remove.
4. Install the new power cord.
5. Reassemble in the reverse order as above.
FAN ASSEMBLY REPLACEMENT -
MOTOR AND HOUSING
Tools Required:
Philips head screwdriver
Flat Head Screwdriver
WARNING:
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
!
NOTE:
Ensure that all of the components that
contain water have been emptied before performing any
maintenance.
1. Carefully remove the rocks from the front tray.
2. Remove the fireplace assembly from the wall by care-
fully lifting it upward, releasing it from the flanges of the
wall-mounting bracket.
3. Carefully set the unit upright on a flat working surface.
!
NOTE:
If necessary, lay a protective barrier between
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
4. Disassemble the sump components. (Figure 9)
5. Remove the 3 screws that hold the cover onto the fan
housing.
6. Remove the fan motor out of the housing and discon-
nect the wiring connection located near the bottom of
the housing.
7. If replacing only the motor, attach new motor and reas-
semble the remainder of the cassette in reverse order
from the instructions above.
• If replacing the housing, remove the 3 screws attaching
the base to the cassette. (Figure 6)
8. Attach new fan housing base to the cassette.
9. Transfer the filter from the old housing to the new hous-
ing.
10. Reinstall the fan motor and reconnect the wire.
11. Re-assemble the remainder of the cassette in reverse
order from the instructions above.
LIGHT ASSEMBLY REPLACEMENT
Tools Required:
Phillips Head Screwdriver
WARNING:
If the fireplace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING:
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Carefully remove the rocks from the front tray.
2. Remove the fireplace assembly from the wall by care-
fully lifting it upward, releasing it from the flanges of the
wall-mounting bracket.
3. Carefully set the unit upright on a flat working surface.
!
NOTE:
If necessary, lay a protective barrier between
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
4. Disassemble the sump components. (Figure 9)
5. Lay the unit carefully down on the back surface.
6. Remove the light bulbs and place in a safe location.
7. Remove the two screws securing the light assembly
and housing bracket to the bottom panel.
8. Lift the assembly out and disconnect the wiring connec-
tions noting their original locations.
9. Remove the light assembly from the housing bracket.
10. Properly orient and install the new light assembly and
connect all of the wiring.
11. Reassemble in the reverse order as above.
Figure 9
