14
www.dimplex.com
Operation
The controls are located on the
right hand side of the fireplace.
Figure 9.
A.
3-Position Switch
The switch has two on positions
marked with and “
ON
”.
The “
ON
” position is for manual
operation. In this position the
built-in remote control is by-
passed.
The position is for operating
the unit with the provided remote
control.
When in position the unit is
operated with the on and oFF
buttons of the remote control.
When the switch is in the center
position the unit is off.
B. Heater On Switch
The Heater on/off switch
supplies power to the heater fan
and the heater element.
When the switch is in the on
position the heater operates if the
thermostat calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your
individual requirements, turn the
thermostat control upward all the
way to turn on the heater. When
the room reaches the desired
temperature, turn the thermostat
knob downward until you hear
a click. Leave in this position to
maintain the room temperature at
this setting. For additional heat,
turn upward until you hear the
click again and the heater will turn
on.
Resetting The Temperature
Cutoff Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset.
It can be reset by switching
the 3-Position switch to oFF
and waiting 5 minutes before
switching the unit back on.
CAUTION:
If you need to
Figure 9
C. Thermostat
B. Heater
on/oFF
switch
A. 3-Position
switch
