4
4. Use studs to frame an opening of 775mm wide X 658mm high X 300mm deep.
The power cord can be routed from behind the trim and along the wall to an outlet
near
the
fi replace. Please make sure the cord is not routed across the top of the fi rebox.
CAUTION
Clearance for air circulation beneath the fi rebox insert is provided by three rubber feet.
DO NOT INSTALL THE FIREBOX INSERT DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH
MAY RESTRICT AIR CIRCULATION. If installing the fi rebox in a carpeted area, place a one-piece, solid,
fl at surface under the fi rebox insert. Ensure that all three of the insert’s feet rest securely on this surface.
OPERATION
REMOTE CONTROL
The remote control has a range of approximately 15 meters.
REMOTE CONTROL INITIALIZATION
This procedure may be required if there is a loss of power to the remote
control in the fi rebox (i.e. power failure, breaker tripped, main power switch is
turned off, remote battery failure) or if a new remote is used.
1. Ensure that power is supplied through main service panel.
2. Locate manual controls. (FIGURE 4)
3. Activate main power switch.
4. Press — (ON) button located on the Manual Selection Control
for 3 seconds (FIGURE 5). All 3 indicators will fl ash.
5. Press the ON button on the transmitter (FIGURE 3). The
indicators
will
fl ash rapidly and then turn off.
This will synchronize the remote control transmitter and receiver.
REMOTE CONTROL USAGE
The remote control operates the fi rebox levels sequentially. The level is
increased every time the ON button on the transmitter is pressed. The fi rebox
can be turned off at any point by pressing the OFF button on the remote
control transmitter, or by switching off the mains switch.
FIGURE 3
FIGURE 4
Manual Controls Located
Under Door
FIGURE 5
Main Selector Switches
Indicator Lights
Thermostat Control
Main Power Switch
