The appliance must be positioned so that
the plug is accessible.
If the supply cord is damaged it must be
replaced by the manufacturer or service
agent or a similarly qualified person in
order to avoid a hazard.
Keep the supply cord away from the front
of the appliance.
Warning: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-
out, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
CAUTION - Some parts of this product
can become very hot and cause burns.
Particular attention has to be given
where children and vulnerable people are
present.
The heater carries the Warning symbol,
indicating that it must not be covered.
This instruction can be found at WWW.
DIMPLEX.CO.UK
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
General
Unpack the heater carefully and retain the packaging for possible future
use, in the event of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without
heating, so that the comforting effect may be enjoyed at any time of the
year. Using the flame effect on its own only requires little electricity.
Before connecting the heater
check that the supply voltage is the same
as that stated on the heater.
Please note: Used in an environment where background noise is very
low, it may be possible to hear a sound which is related to the operation
of the flame effect. This is normal and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked
on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
instructions.
Fixing
- see
Fig. 3
The appliance should fitted the nylon strap provided, the purpose of this
strap is to prevent the Marbello Electric Fire Suite falling over.
Step 1. screw the strap to the suite with one of the two screws provided
as illustrated in Fig.3.
Step 2. Drill a hole in the wall using a 6mm drill bit in to the wall and
place the plastic plug provided into the wall.
Step 3. Place the free end of the nylon strap over the newly drilled hole
and screw the remainging scew into the wall plug, ensure the fitting is
sucure
NOTE: Fittings provided are for a block wall only, special fitting are
required for stud walls which are not provided with the product
UK
Important Safety Advice
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electrical shock and
injury to persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings
of a bath, shower or swimming pool.
Do not locate the appliance immediately
below a fixed socket outlet or connection
box.
The appliance carries the Warning symbol
DO NOT COVER, indicating that it must not
be covered.
This appliance can be used by children
aged form 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by Children without supervision.
Children of less than 3 years should
be kept away unless continuously
supervised. Children aged from 3 years
and less than 8 years shall only switch
on/off the appliance provided that it has
been placed or installed in its intended
normal operating position and they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understanding the hazards
involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate
and clean the appliance or perform user
maintenance.
Do not use this appliance in series with
a thermal control, a program controller,
a timer or any other device that switches
on the heat automatically, since a fire risk
exists when the appliance is accidentally
covered or displaced.
Ensure that furniture, curtains or other
combustible material are positioned no
closer than 1 metre from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required
for long periods.
Although this appliance complies with
safety standards, we do not recommend
its use on deep pile carpets or on long hair
type of rugs.
Summary of Contents for Marbello
Page 2: ...1 2 3 ...