10
EDS7001F
If the unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/FLAME ROD
14. Remove the flame rod from the flame motor by pulling the end of the rod to the
left and cut the reflector spring with wire cutters.
DO NOT TAKE THE
LEFTOVER SPRING OFF THE END OF THE REFLECTOR ROD
15. Remove the (2) motor mounting screws with a short handled screw driver.
16. Discard the old flicker motor.
17. Pick up the 1 ½” rubber sleeve and locate over remaining spring on reflector rod.
ENSURE TO LOCATE THE LARGE OPENING OF THE RUBBER SLEEVE
OVER THE REMAINING SPRING OF THE REFLECTOR ROD.
18. Properly orientate the flame motor and connect all of the wiring clips and
connections in their original locations.
19. Reassemble in the reverse order as above.
