Controls
- see
Fig. 2
Three switches provide a choice of heat settings. A switch is in the ON
position when the side with the markings on (i.e.
I
,
I
, or
II
) is pushed in.
Switch 1 (I)
Controls the electricity supply to the heater and
the flame effect.
Note: This switch must be in the ON (I) position
for heater to operate with or without heat.
Switch 2 (I)
Provides 750W heat output
Switch 3 (II)
Provides 1500W heat output with switch 2 in the
ON positon also.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance automatically
in the event of a fault. Switch off the appliance or disconnect the mains
plug from the socket. After a short cooling down phase, the appliance
is
ready for use again. If the fault should occur again, see your local
dealer.
WARNING: This heater is not equipped with a device to control the
room temperature. Do not use this heater in small rooms when they
are occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place of
traditional incandescent bulbs. These generate the same light levels
as
traditional bulbs, but use a fraction of the energy consumed.
Recycling
At the end of the electrical product’s useful life it should
not be disposed of with household waste.
Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice in your
country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
After Sales Service
Please see the separate Warranty leaflet for details of your Warranty &
After Sales Service including contact details.
Should you require after sales information or assistance with this product,
please contact Glen Dimplex Australia on 1300 556 816 (AUS) / 09 274
8265 (NZ) or visit our website at
www.dimplex.com.au
(AUS) /
www.dimplex.co.nz
(NZ).
Glen Dimplex Australia
8 Lakeview Drive,Scoresby,
VIC 3179,
Australia
www.dimplex.com.au
sales@glendimplex.com.au
Ph: 1300 556 816
Glen Dimplex Australasia Ltd.
38 Harris Road,
East Tamaki,
Auckland 2013
New Zealand
www.dimplex.co.nz
sales@glendimplex.co.nz
Ph: +61 9 274 8265
c
Glen Dimplex.
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in
writing from Glen Dimplex.
This product is protected by Intellectual property rights and patents owned by the Glen Dimplex Group on an international basis.
The Glen Dimplex Group of Companies will actively protect these rights.
