8. Only use the appliance inside (indoors) and only for the purpose it was designed.
9. Do not use this appliance or position any part of it near to heat, open flame, cooking appliances
or any heating appliance, there is a risk of it being damaged or a dangerous situation resulting..
10. Do not place heavy objects on the appliance or any object against the product when operating.
11. Do not use the appliance in an area where there are likely to be flammable or explosive fumes
or liquids.
12. Only use the appliance on a stable and level surface.
13. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
14.
When the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
15. Unplug the appliance before cleaning.
16. To unplug the appliance do not pull on the mains cable, grip the plug at the wall outlet and pull
carefully.
17. Should the appliance fail to operate please check the fuse in the plug is intact and confirm that
the circuit breaker / fuse at your distribution board is operating before contacting the
manufacturer or service agent.
☆
HOW TO ASSEMBLE THE BASE
Carefully remove the split base and the tower fan from its packaging.
Pass the power cord between the two half’s of the split base at the
centre and fit the two half’s together by lining up the overlap bosses
on the back half (with the cable exit) with their sockets on the other
half and dropping into place and pressing together.
Bring the assembled base up to the bottom of the tower and line up
the small pillar on the top of the raised centre of the base with the
matching hole in the base socket location of the tower fan, pull the
cable through fully so it doesn’t interfere with them fitting together.
Take the 4 large screws provided and pass them through the holes
in the circular bosses (located around the central hub on the underside
of the base) into the bottom of the tower, screw fix them firmly in place.
Carefully fit the cable through the slot to the back side of the hub and
then through the guide location channel at the outside of the circular
base to exit level with the base through the channel at the back.
Your Mont Blanc Cooling Fan is now ready to stand and operate.
