6
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool before
touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark
section of the flame. There are two (2) bulbs behind the log
set which generate the flames and embers
.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they
are close to the end of their rated life. Group replacement
will reduce the number of times you need to open the unit to
replace light bulbs.
Lower Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with
an E-12 (small) socket base, 60 Watt rating.
Do not exceed 60 Watts per bulb
To access the light bulb area (Figure 2):
1. Remove the four (4) silver Phillips screws on the Access
Panel at the rear of the fireplace and remove panel.
2. Examine the bulbs to determine which bulbs require
replacement.
3. Hold the socket while unscrewing the bulb.
4. Hold the socket while screwing in the new bulb.
5. Reattach Access Panel with screws removed in step 1.
Mirror Replacement
If the fireplace was operating prior to servicing allow at least
five (5) minutes for light bulbs and heating element to cool off
to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Replacement Procedure
1. Pull fireplace away from the wall far enough to access
the back of the unit.
2. Remove two (2) Phillips screws from each of the four (4)
brackets which attach the fireplace to the mantel
(Figure 3).
3. Carefully push fireplace out the front of the mantel to
remove (Figure 4).
Light Bulbs (2)
Access Panel
Figure 2
Screws to
remove (4)
4. Turn fireplace on it’s back and remove the four (4)
Phillips screws that attach the Trim to the fireplace (if
applicable) (Figure 5, Page 7).
5. Turn the fireplace upright and slide the Trim up to unhook
the Trim from the fireplace and remove.
6. Remove the three (3) sided Cover:
i) From the bottom of the fireplace, remove the four (4)
Phillips screws as shown in Figure 6 (Page 7).
Figure 3
(4)
(2)
(2)
(2)
(2)
(4)
(2)
(2)
(2)
(2)
Figure 4
!
NOTE:
The top tab of the Access Panel will tuck inside
the fireplace and the top screw will pass through the
Access Panel and screw into the fireplace’s outer cover.
Summary of Contents for Mozart CFP3811
Page 5: ...5 Wiring Diagram ...
