17
Do not exceed 15 Watts per
bulb.
To access the upper light bulb
area:
slide fireplace out of mantel.
1.
Remove four (4) Phillips
2.
screws from right side of trim
(Figure 6).
remove trim.
3.
Slide glass to the right side of
4.
the fireplace to remove (Figure
6).
remove upper Light Bracket
5.
(Figure 6).
upper bulbs are located in
6.
the upper left and upper right
corners of the fireplace.
unscrew bulbs counter
7.
clockwise.
Insert new bulbs and screw in
8.
clockwise.
re-install upper Light Bracket.
9.
slide front glass back into
10.
position and attach trim.
Purifire™ Filter
The Purifire™ filter supplied in
your fireplace is reusable and
washable. The filter should be
cleaned or replaced on average
once a year. To clean the filter
gently tap filter on a hard surface
to dislodge any loose dirt or
debris, and then clean with water.
no soap or cleaning products are
recommended. The filter size
is 20 x 10 x 1 inches, rated at
mErV 10.
To replace filter:
remove fireplace from mantel.
1.
Filter can be accessed from
2.
the top rear of the unit (Figure
8).
Grasp filter and slide filter
3.
straight up.
replace or clean filter.
4.
!
NOTE:
If after market air
filter is used ensure it is
Maintenance
Figure 8
Purifire™
Filter
