7
This section provides instructions
for selecting a location and
preparing the site to install the
fireplace into your Dimplex mantel
surround.
select a suitable location that
1.
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
For ease of electrical hook
2.
up you may wish to locate
the fireplace near an existing
outlet (refer to noTE 1).
store the fireplace in a safe
3.
dry and dust free location.
!
NOTE 1:
A 15 Amp, 120
Volt circuit is required. A
dedicated circuit is preferred
but not essential in all cases.
A dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker
.
WARNINg:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
Construction and electrical
outlet wiring must comply with
Quick Reference guide
①
The information regarding the
model of your electric fireplace
can be found on the label located
on the back of the unit.
②
If you have any technical
questions or concerns regarding
the operation of your electric
fireplace, or require service
contact customer service.
③
The heater on your fireplace
may emit a slight, harmless odor
when first used. This odor is a
normal condition caused by the
initial heating of internal heater
parts.
Site Selection and Preparation
