Thermostat
Fig. 6
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to pre-
vent damage due to overheating.
This can happen if the heat outlet was restricted in any way.
The heater will switch on once the obstruction has been re-
moved and the heater has cooled. If the cut-out continues to
operate intermittently, the heater should be switched off and
a service agent contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Instructions for fitting Coal Option
Introduction
Your fire is provided with a coal effect option. Simply follow
the instructions given below.
Removal of Log Effect
Remove the four screws securing the log effect
assembly and
slide out ( see Fig. 7).
Fitting Coal Effect
Fit the coal effect in position and secure with the four screws
(see fig. 8)
Place the coal lumps on the fuel bed. A plastic glove is pro-
vided for
handling the coal.
Note:
The log effect should be stored away for possible fu-
ture use.
Fig. 7
Fig. 8
Lamp Replacement
To gain access to the lamps remove the coal/log effect from
the fire by unscrewing the four fixing screws from the fuel bed
and sliding out the fuel effect.
Unscrew any defective lamps (see Fig. 9) and replace
with240V, 25 watt E14 SES clear candle lamp. Do not
overtighten.
Refit fuel effect, securing with the four fixing screws.
Fig. 9
