Dimplex Revillusion RBF30, Service Manual

4             www.dimplex.com

Icon

Function

Description

Heat Enable

Heat Disable

Hold both Heat (

) and Temp– (

), on the unit, for 2 seconds. Temperature displays 

on the screen.
Hold both Heat (

) and Temp–  (

), on the unit, for 2 seconds, when temperature is 

adjusted "---" displays on the screen.

E

Color 
Themes

Press multiple times to change the flame base colors from Red to Blue to Off. (The first 

segment on the display will change from "r" to "b" to blank) This feature is active only 

when the flame effect is On.  

F

360

o

 Light

Press multiple times to change the LEDs on the sides and back of the unit from Midnight 

mode to white to yellow to red. (The middle segment on the display will change through 

0 - 3 respectively. This feature is active only when the Flame is ON.)  

G

Brightness

Press to change the LED lights from High to Low. (The last segment on the display will 

change from "H" to "L") The Realog

TM

 LEDs remain On when the heater is ON and the 

flame effect is Off.

!

NOTE: 

When the Light Sensor is activated, High and Low flickering brightness 

settings are also available (Flashing "H" and "L").

H

Flame

Press to light the log set and start the flame effect. Press again to turn feature Off.

I

Light 

Sensor

Press to activate the ambient light sensor (ALS ON). Press again to turn the sensor off 

(ALS OFF).

!

NOTE: 

The light sensor will adjust the brightness of the fireplace based on the 

ambient light in the room.

J

Timer

Press multiple times to change the sleeper timer in 0.5 hr increments from 0.5 hr to 8.0 hr 

before turning off. The remaining time on the sleep timer displays.  

Control Lock

Control Unlock

Hold both Temp– (

) and Brightness (

), on the unit, for 2 seconds to disable the 

manual controls. 
Hold both Temp– (

) and Brightness (

), on the unit, for 2 seconds to enable the 

manual controls. 

Resetting the Temperature Cutoff Switch 

Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It 

can be reset by disconnecting power at the main electrical panel and waiting 5 minutes before plugging the unit back in. 

 CAUTION: 

 If you need to con tinuously reset the heater, unplug the unit and call technical support at 1-888-346-7539.