Dimplex Revillusion RBF30, Service Manual

5

MAINTENANCE

General Maintenance

Inspect the built-in electric firebox regularly, depending 

upon conditions, and at a minimum yearly intervals. 

Remove dust and clean the logs, grate, and base as 

required.

WARNING:

  Disconnect power and allow heater to cool 

before attempting any maintenance or cleaning to reduce 

the risk of fire, electric shock, or injury.

CAUTION

:  Except for installation and cleaning 

described in this manual, an authorized service 

representative should perform any other servicing.

Clean Logs and Base

The built-in electric firebox set should not be operated with 

an accumulation of dust or dirt on or in the firebox, as this 

can cause a build up of heat and eventual damage. 

Dust and vacuum the firebox as needed. Use a damp cloth 

and a mild detergent to clean painted surfaces of the built-

in electric firebox. Never use abrasive cleaners. 

Clean Reflector Screen

The reflector screen is cleaned in the factory during the 

assembly operation. During shipment, installation, handling, 

etc., the screen may collect dust particles; these can be 

removed by dusting lightly with a clean dry cloth.

To remove fingerprints or other marks, clean the reflector 

screen damp cloth. Never use abrasive cleaners. Dry the 

screen completely with a lint free cloth to prevent water 

spots. 

Remote Battery Replacement

To replace the battery:

1.  Push down on the battery cover located on the back of 

the remote control. Slide the battery cover open. 

2.  Install 3V (CR2032) Lithium battery in the battery 

holder. The positive (+) side of the battery faces up.  

3.  Close the battery cover. 

The old battery must be recycled or disposed of properly. 

Check with your Local Authority or Retailer for recycling 

advice in your area.

CAUTION

:  

When transporting or storing the heater and cord, 

keep in a dry place, free from excessive vibration and store so as 

to avoid damage.