background image

Dimplex
Millbrook House
GrangeDrive
HedgeEnd
Southampton
Hampshire.SO30 2DF

TEL: 0845 600 5111
FAX: 01489 773050
WEBSITE: www.dimplex.co.uk
Republic of Ireland Tel.

01 8424833

[c] GDC Group Ltd,

All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex.

A division of GDC Group Ltd,

Sahara

Model: SHR12

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

UK

Battery information 

- see 

Fig. 6

1. Slide open the battery cover on the back of the remote
control.
2. Install AAA batteries into the remote control.
3. Replace the battery cover.
Discard leaky batteries. Dispose of batteries in the proper
manner according to provincial and local regulations. Any
battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all the batteries are not replaced
at the same time, if disposed of in a fire, or if an attempt is
made to charge a battery not intended to be recharged.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE  ATTEMPTING  ANY  MAINTENANCE.

Lamp Replacement 

- see 

Fig. 3, Fig. 4 and Fig. 5

Turn off the appliance.

Allow at least  15 minutes for light bulbs  to cool before
touching bulbs to avoid accidental burning of skin.

Remove the outer frame by lifting it up and out at the bottom.

(Fig 3).

Warning ! The outer frame is  heavy.

Remove the 4 screws holding the light baffel in place (Fig. 4).

Slide the light baffel out to the front  (Fig. 5).
Remove the defective lamp by unscrewing it as shown in (Fig.5).
Replace with a 60W E14 SES Clear Candle lamp.
Take care not to over-tighten the lamp.

Thermal Safety Cut-out

A thermal safety cut-out is incorporated in the heater to prevent
damage due to overheating. This can happen if the heat outlet
was restricted in any way. The heater will switch on once the
obstruction has been removed and the heater has cooled. If
the cut-out continues to operate intermittently, the heater should
be switched off and a service agent contacted.

Recycling

For electrical products sold within the European
Community.  At the end of the electrical products
useful life it should not be disposed of with
household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for
recycling advice in your country.

After Sales Service

Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (excluding lamps & subject to
availability) provided it has been installed and operated in
accordance with these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.

Should you require after sales information or assistance with
this product please go to 

www.dimplex.co.uk 

where you will

find our self help guide by clicking on “After Sales” or ring our
helpdesk on 0845 600 5111 (UK) or 01 842 4833 (R.O.I.)  .
Spare parts are also available on the website

www.dimplex.co.uk

Please retain your receipt as proof of purchase

.

Summary of Contents for SAHARA SHR12








Reviews: