17
SF3202
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE POWER CORD
1. Remove the firebox from the back of the mantel.
2. Remove the retaining screws on the top panel and remove the top being careful not
to damage any of the wiring.
3. Located and disconnect the power cord wiring connections noting their original
locations from the circuit board.
4. With needle nose pliers grasp the power cord strain relief grommet from inside the
rear panel and push while twisting to remove.
5. Pull the power cord out through the hole in the rear cover.
6. Install the new cord set through the hole in the side panel by placing the strain relief
over the cord, hold the strain relief with pliers and slide into mounting hole.
7. Connect all of the wiring connections in their original locations on the circuit board.
8. Reassemble in the reverse order as above.
